Kaizen
Back
Warpage issue in Shark 5G MB
Previously we were facing warpage issue in Shark 5G on printer top side after reflow bottom side pcb due to this facing dry solder , low volume & shorting issue on line.
Now we are using pallet fixture on bottom side and remove dowell pin from bottom pallet to reduce the pcb shrinkage issue so we get better result on printer and reduce smt failure also
12-05-2025
21-05-2025
Quality
HOD Okby : Ankur Sharma
KPO: Approvedby : Jyoti Prasad Mallick
CI: okby : Shubham Srivastava
